#1 (permalink) Sun Jan 24, 2010 2:43 am Summary report. |
|
|
I have a report to sumary a technical issue, as below:
"We have already completed re-calculation all gas meters with new method calculation was applied. based on data before and after calculating, almost meters are reading higher than before but. this is mainly based on flow control valve are same of opening position in comparison with both case (before/after calculation) while others condition are no change (upstream/downstream pressure). therefore we have incresed setpoint of these FCV to meet flow requiments. the resulting total gas volume has been increased about 10cubit ft by reading but actual flow rate are no change"
please correct my misktake. thank you very much.
Binbin |
|
Binbin93 I'm new here and I like it ;-)
Joined: 03 Oct 2009 Posts: 44
|